NILE CHEMICALS

ALUMINUM AMMONIUM SULFATE


1. Product Identification

Synonyms: Aluminum ammonium Sulphate

CAS No.: 7784-25-0 (Anhydrous) 7784-26-1 (Dodecahydrate)
Molecular Weight: 453.32
Chemical Formula: AlNH4(SO4)2 . 12H2O
Product Codes:  923


2. Composition/Information on Ingredients

  Ingredient                                CAS No         Percent        Hazardous                                  
  ---------------------------------------   ------------   ------------   ---------   
 
  Sulfuric Acid, Aluminum Ammonium Salt     7784-25-0        98 - 100%       Yes                                                                    
 

3. Hazards Identification

Potential Health Effects
This material hydrolyzes in water to form sulfuric acid, which is responsible for the irritating effects given below.
Inhalation: Causes irritation to the respiratory tract. Symptoms may include coughing, shortness of breath.
Ingestion: Causes irritation to the gastrointestinal tract. Symptoms may include nausea, vomiting and diarrhea. There have been two cases of fatal human poisonings from ingestion of 30 grams of alum.
Skin Contact: Causes irritation to skin. Symptoms include redness, itching, and pain.
Eye Contact: Causes irritation, redness, and pain.
Chronic Exposure: No information found.
Aggravation of Pre-existing Conditions: No information found.


4. First Aid Measures

Inhalation: Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Get medical attention.
Ingestion: If swallowed, DO NOT INDUCE VOMITING. Give large quantities of water. Never give anything by mouth to an unconscious person. Get medical attention ediately.
Skin Contact: Wipe off excess material from skin then immediately flush skin with plenty of water for at least 15 minutes. Remove contaminated clothing and shoes. Get medical attention. Wash clothing before reuse. Thoroughly clean shoes before reuse.
Eye Contact: Immediately flush eyes with plenty of water for at least 15 minutes, lifting upper and lower eyelids occasionally. Get medical attention.


5. Fire Fighting Measures

Fire: Not considered to be a fire hazard. May release flammable ammonia if involved in  fire.
Explosion: Not considered to be an explosion hazard. Sealed containers may rupture when heated.
Fire Extinguishing Media: Use any means suitable for extinguishing surrounding fire. Keep in mind that addition of water can cause the formation of sulfuric acid.
Special Information: In the event of a fire, wear full protective clothing and NIOSH-approved self-contained breathing apparatus with full facepiece operated in the pressure demand or other positive pressure mode.


6. Accidental Release Measures

Cover spill with sodium bicarbonate or soda ash and mix. Ventilate area of leak or spill. Keep unnecessary and unprotected people away from area of spill. Wear appropriate personal protective equipment as specified in Section 8. Spills: Pick up and place in a suitable container for reclamation or disposal, using a method that does not generate dust. 


7. Handling and Storage

Keep in a tightly closed container, stored in a cool, dry, ventilated area. Protect against physical damage. Isolate from incompatible substances. Containers of this material may be hazardous when empty since they retain product residues (dust, solids); observe all warnings and precautions listed for the product.


8. Exposure Controls/Personal Protection

Airborne Exposure Limits: -OSHA Permissible Exposure Limit (PEL):15 mg/m3 (TWA) total dust and 5 mg/m3 (TWA)
respirable fraction for Aluminum metal as Al.-ACGIH Threshold Limit Value (TLV): 1 mg/m3 respirable fraction (TWA), Aluminum metal and Insoluble compounds, A4.
Ventilation System: A system of local and/or general exhaust is recommended to keep employee exposures below the Airborne Exposure Limits. Local exhaust ventilation is generally preferred because it can control the emissions of the contaminant at its source, preventing dispersion of it into the general work area. Please refer to the ACGIH document, Industrial Ventilation, A Manual of Recommended Practices, most recent edition, for details.
Personal Respirators (NIOSH Approved): If the exposure limit is exceeded, a half-face dust/mist respirator may be worn for up to ten times the exposure limit or the maximum use concentration specified by the appropriate regulatory agency or respirator supplier, whichever is lowest. A full-face piece dust/mist respirator may be worn up to 50 times the exposure limit, or the maximum use concentration specified by the appropriate regulatory agency, or respirator supplier, whichever is lowest. For emergencies or instances where the exposure levels are not known, use a full-facepiece positive-pressure, air-supplied respirator. WARNING: Air-purifying respirators do not protect workers in oxygen-deficient atmospheres.
Skin Protection: Wear impervious protective clothing, including boots, gloves, lab coat, apron or coveralls, as appropriate, to prevent skin contact.
Eye Protection: Use chemical safety goggles and/or full face shield where dusting or splashing of solutions is possible. Maintain eye wash fountain and quick-drench facilities in work area.

9. Physical and Chemical Properties

Appearance: Colorless crystals.
Odor: Odorless.
Solubility: 14% in water, 200% in boiling water
Density: 1.65
pH: 4.6 (0.05M solution)
% Volatiles by volume @ 21C (70F): 0
Boiling Point: 280C (536F) Decomposes.
Melting Point: 94.5C (201F)
Vapor Density (Air=1): No information found.
Vapor Pressure (mm Hg): No information found.
Evaporation Rate (BuAc=1): No information found.


10. Stability and Reactivity

Stability: Stable under ordinary conditions of use and storage.
Hazardous Decomposition Products: Toxic oxides of nitrogen, sulfur dioxide, ammonia, and sulfur trioxide may form at elevated temperatures. Hydrolyzes to form sulfuric acid.
Hazardous Polymerization: Will not occur.
Incompatibilities: Contact with alkalis may release ammonia gas. Corrosive to metals in the presence of water.

Conditions to Avoid: Moisture and incompatibles.


11. Toxicological Information

No LD50/LC50 information found relating to normal routes of occupational exposure.

  --------\Cancer Lists\------------------------------------------------------
                                         ---NTP Carcinogen---
  Ingredient                             Known    Anticipated    IARC Category
  ------------------------------------   -----    -----------    -------------
  Sulfuric Acid, Aluminum Ammonium        No          No            None
  Salt (2:1:1) (7784-25-0)

12. Ecological Information

Environmental Fate: No information found.
Environmental Toxicity: No information found.


13. Disposal Considerations

Whatever cannot be saved for recovery or recycling should be managed in an appropriate and approved waste disposal facility. Processing, use or contamination of this product may change the waste management options. State and local disposal regulations may differ from federal disposal regulations. Dispose of container and unused contents in accordance with federal, state and local requirements.


14. Transport Information

Not regulated.


15. Regulatory Information

  --------\Chemical Inventory Status - Part 1\---------------------------------
  Ingredient                                       TSCA  EC   Japan  Australia
  -----------------------------------------------  ----  ---  -----  ---------
  Sulfuric Acid, Aluminum Ammonium Salt (2:1:1)     Yes  Yes   Yes      Yes                                      
  (7784-25-0)
 
  --------\Chemical Inventory Status - Part 2\---------------------------------
                                                          --Canada--
  Ingredient                                       Korea  DSL   NDSL  Phil.
  -----------------------------------------------  -----  ---   ----  -----
  Sulfuric Acid, Aluminum Ammonium Salt (2:1:1)     Yes   Yes   No     No                            
  (7784-25-0)
 
  --------\Federal, State & International Regulations - Part 1\----------------
                                             -SARA 302-    ------SARA 313------
  Ingredient                                 RQ    TPQ     List  Chemical Catg.
  -----------------------------------------  ---   -----   ----  --------------
  Sulfuric Acid, Aluminum Ammonium Salt      No    No      No         No
  (2:1:1) (7784-25-0)
 
  --------\Federal, State & International Regulations - Part 2\----------------
                                                        -RCRA-    -TSCA-
  Ingredient                                 CERCLA     261.33     8(d) 
  -----------------------------------------  ------     ------    ------
  Sulfuric Acid, Aluminum Ammonium Salt      No         No         No                 
  (2:1:1) (7784-25-0)
 

16. Other Information

Nile Chemicals. provides the information contained herein in good faith but makes no representation as to its comprehensiveness or accuracy. This document is intended only as a guide to the appropriate precautionary handling of the material by a properly trained person using this product. Individuals receiving the information must exercise their independent judgment in determining its appropriateness for a particular purpose. NILE CHEMICALS. MAKES NO REPRESENTATIONS OR WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING WITHOUT LIMITATION ANY WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE WITH RESPECT TO THE INFORMATION SET FORTH HEREIN OR THE PRODUCT TO WHICH THE INFORMATION REFERS. ACCORDINGLY, NILE CHEMICALS. WILL NOT BE RESPONSIBLE FOR DAMAGES RESULTING FROM USE OF OR RELIANCE UPON THIS INFORMATION.

Product range

Ph Indicator Chemicals  Lab    Bulk       Catalyst Food Colour  Herbs Intermediates
Cesium Salts Ion Pair Reagents Direct Dyes Contact details Acid Dyes Solvents

AA   BC   DM   N S   T Z
nilesh@nilechemicals.comsales@nilechemicals.com