NILE CHEMICALS

SODIUM ACETATE


1. Product Identification

CAS No.: 127-09-3 (Anhydrous); 6131-90-4 (Trihydrate)
Molecular Weight: 136.08
Chemical Formula: CH3COONa 3H2O
Product Codes: 191143

2. Composition/Information on Ingredients

  Ingredient                                CAS No         Percent        Hazardous                                  
  ---------------------------------------   ------------   ------------   ---------   
 
  Sodium Acetate                            127-09-3         99 - 100%       Yes

3. Hazards Identification

Inhalation:May cause irritation to the respiratory tract. Symptoms may include coughing, sore throat, labored breathing, and chest pain.
Ingestion:Large doses may produce abdominal pain, nausea, and vomiting.
Skin Contact:May cause irritation with redness and pain.
Eye Contact:Contact may cause irritation, redness, and pain.
Chronic Exposure:No information found.
Aggravation of Pre-existing Conditions:No information found.

4. First Aid Measures

Inhalation:Remove to fresh air. Get medical attention for any breathing difficulty.
Ingestion:Give several glasses of water to drink to dilute. If large amounts were swallowed, get medical advice.
Skin Contact:Immediately flush skin with plenty of water for at least 15 minutes. Remove contaminated clothing and shoes. Wash clothing before reuse. Thoroughly clean shoes before reuse. Get medical attention if irritation develops.
Eye Contact:Immediately flush eyes with plenty of water for at least 15 minutes, lifting upper and lower eyelids occasionally. Get medical attention if irritation persists.

5. Fire Fighting Measures

Fire:Autoignition temperature: 611C (1132F)
As with most organic solids, fire is possible at elevated temperatures or by contact with an ignition source. Listed fire data is for the Anhydrous Material.
Explosion:Fine dust dispersed in air in sufficient concentrations, and in the presence of an ignition source is a potential dust explosion hazard.
Fire Extinguishing Media:Water spray, dry chemical, alcohol foam, or carbon dioxide.
Special Information:In the event of a fire, wear full protective clothing and NIOSH-approved self-contained breathing apparatus with full facepiece operated in the pressure demand or other positive pressure mode.

6. Accidental Release Measures

Remove all sources of ignition. Ventilate area of leak or spill. Wear appropriate personal protective equipment as specified in Section 8. 

7. Handling and Storage

Keep in a tightly closed container, stored in a cool, dry, ventilated area. Protect against physical damage. Isolate from any source of heat or ignition. Containers of this material may be hazardous when empty since they retain product residues (dust, solids); observe all warnings and precautions listed for the product.

8. Exposure Controls/Personal Protection

Airborne Exposure Limits:None established.
Ventilation System:A system of local and/or general exhaust is recommended to keep employee exposures as low as possible. Local exhaust ventilation is generally preferred because it can control the emissions of the contaminant at its source, preventing dispersion of it into the general work area. Please refer to the ACGIH document, Industrial Ventilation, A Manual of Recommended Practices, most recent edition, for details.
Personal Respirators (NIOSH Approved):For conditions of use where exposure to dust or mist is apparent and engineering controls are not feasible, a particulate respirator (NIOSH type N95 or better filters) may be worn. If oil particles (e.g. lubricants, cutting fluids, glycerine, etc.) are present, use a NIOSH type R or P filter. For emergencies or instances where the exposure levels are not known, use a full-face positive-pressure, air-supplied respirator. WARNING: Air-purifying respirators do not protect workers in oxygen-deficient atmospheres.
Skin Protection:Wear protective gloves and clean body-covering clothing.
Eye Protection:Use chemical safety goggles. Maintain eye wash fountain and quick-drench facilities in work area.

9. Physical and Chemical Properties

Appearance:Colorless crystals.
Odor:Slight acetic acid odor.
Solubility:76 gm/100mls water @ 0C
Density:1.45
pH:8.9
% Volatiles by volume @ 21C (70F):0
Boiling Point:Not applicable.
Melting Point:Loses water @ 120C (248F); decomposes @ 324C (615.2F)
Vapor Density (Air=1):No information found.
Vapor Pressure (mm Hg):No information found.
Evaporation Rate (BuAc=1):No information found.

10. Stability and Reactivity

Stability:Stable under ordinary conditions of use and storage.
Hazardous Decomposition Products:Emits fumes of acetic acid upon heating and on contact with strong acids.
Hazardous Polymerization:Will not occur.
Incompatibilities:Nitric acid, fluoride, potassium nitrate, strong oxidizers and diketene.
Conditions to Avoid:Incompatibles.

11. Toxicological Information

Hydrate: Investigated as a mutagen. Anhydrous: Oral rat LD50: 3530 mg/kg; inhalation rat LC50: > 30 gm/m3; skin rabbit LD50: > 10 gm/kg; Irritation Data, standard Draize: Skin rabbit 500 mg/24H, mild; standard Draize, Eye rabbit 10 mg, mild. Investigated as a mutagen.
  --------\Cancer Lists\------------------------------------------------------
                                         ---NTP Carcinogen---
  Ingredient                             Known    Anticipated    IARC Category
  ------------------------------------   -----    -----------    -------------
  Sodium Acetate (127-09-3)               No          No            None

12. Ecological Information

Environmental Fate:No information found.
Environmental Toxicity:Freshwater Fish Species Data: 24 Hr LC50 Lepomis macrochirus: 5000 mg/L
Microtox Data: 18 Hr EC50 Pseudomonas putida: 7200 mg/LWater Flea Data: 48 Hr EC50 water flea: 5800 mg/L

13. Disposal Considerations

Whatever cannot be saved for recovery or recycling should be managed in an appropriate and approved waste disposal facility. Processing, use or contamination of this product may change the waste management options. State and local disposal regulations may differ from federal disposal regulations. Dispose of container and unused contents in accordance with federal, state and local requirements.

14. Transport Information

Not regulated.

15. Regulatory Information

  --------\Chemical Inventory Status - Part 1\---------------------------------
  Ingredient                                       TSCA  EC   Japan  Australia
  -----------------------------------------------  ----  ---  -----  ---------
  Sodium Acetate (127-09-3)                         Yes  Yes   Yes      Yes                                      
 
  --------\Chemical Inventory Status - Part 2\---------------------------------
                                                          --Canada--
  Ingredient                                       Korea  DSL   NDSL  Phil.
  -----------------------------------------------  -----  ---   ----  -----
  Sodium Acetate (127-09-3)                         Yes   Yes   No     Yes      
 
  --------\Federal, State & International Regulations - Part 1\----------------
                                             -SARA 302-    ------SARA 313------
  Ingredient                                 RQ    TPQ     List  Chemical Catg.
  -----------------------------------------  ---   -----   ----  --------------
  Sodium Acetate (127-09-3)                  No    No      No         No
 
  --------\Federal, State & International Regulations - Part 2\----------------
                                                        -RCRA-    -TSCA-
  Ingredient                                 CERCLA     261.33     8(d) 
  -----------------------------------------  ------     ------    ------
  Sodium Acetate (127-09-3)                  No         No         No  

16. Other Information

Nile Chemicals  provides the information contained herein in good faith but makes no representation as to its comprehensiveness or accuracy. This document is intended only as a guide to the appropriate precautionary handling of the material by a properly trained person using this product. Individuals receiving the information must exercise their independent judgment in determining its appropriateness for a particular purpose. NILE CHEMICALS MAKES NO REPRESENTATIONS OR WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING WITHOUT LIMITATION ANY WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE WITH RESPECT TO THE INFORMATION SET FORTH HEREIN OR THE PRODUCT TO WHICH THE INFORMATION REFERS. ACCORDINGLY, NILE CHEMICALS WILL NOT BE RESPONSIBLE FOR DAMAGES RESULTING FROM USE OF OR RELIANCE UPON THIS INFORMATION.

BACK

www.nilechemicals.com
nilesh@nilechemicals.comsales@nilechemicals.com